instruction have you push bushing into hole in canopy frame with your rivet squeezer. I could push mine in with my fingers. asked a machinist how I could get bushing tight. He said you could tighten a hole by putting a ball over the hole and hitting it with a hammer it seems like it would open the hole but it tightens it. I did not have faith so I was very gentile but it did work amazingly well. I put the frame tab on a steel table a friend held the frame so I could place a one inch diameter steel ball bearing over the hole and taped the ball gently because I expected it not to work. but after I had to get the bushing started from the other side of the hole and use my rivet squeezer to push it in
Last edited: