E

EricB

Member
Hi All,

Quick question on the washers used for the AN3-7A Bolts that connect the tie down assembly to the wing. The instructions list the bolt, nut, and 2 AN960 washers (an AN960-10 and an AN960-10L washer). Question is, which side does the 10L washer go on. Under the Bolt head or under the nut?

Aslo, the 10L is the thinner washer correct?

thanks
 
i asked the same question when doing mine eric. the short answer i got was, it doesn't really matter. i think i put the 10L under the bolt head, and the thicker one with the nut. i believe it's more for spacing. someone correct me if i'm wrong...mine aren't torqued yet.
 
You must log in or register to reply here.