Please see the attached photo that shows the one inch hole through the rear of the left gear tower in my 1997 RV-8 kit. It was manufactured this way and shows the one hole on the plans. I would like to know how I can increase the size of, or reshape the hole to allow the two control cables to pass through. After looking at various sites that show this, I see many pictures of three holes in the back side of the gear tower that match the holes in the F-864 cable anchor. Did the kit change this in later versions? Worried about structurally harming the tower.
Thanks, Rich
http://i65.tinypic.com/smbtxx.jpg
Thanks, Rich
http://i65.tinypic.com/smbtxx.jpg
Last edited: