[redmark]

I've completed the mechanical sync between the two carbs which looks fine at idle... the one item I noted is that at full throttle I now have a little slack in the cables, is this common? or do I need to redo the mechanical sync?

Thanks,
-Ron

 

[Geico266]

Yes, a little slack or "bend" in the throttle cable is normal at full throttle on the Rotax 912.

Does your set up have the cable idle stops?

 

[redmark]

Larry,

Yes... it has the stops that slide over the cable. I was at OSH and took at good look at your engine setup, cowling clearances and muffler mod. I did note that your throttle & choke cables were different from mine... they have some kind of coating or covering.

Thanks,
-Ron