My first time priming today. S/W P60G2 at 1.75:1. Check out these speckles. Google says air pressure was too low to atomize. Can anyone else confirm?
![AEECA2B0-531F-405A-8FE5-69A7B0E048EC.jpeg AEECA2B0-531F-405A-8FE5-69A7B0E048EC.jpeg](https://vansairforce.net/data/attachments/11/11373-7bed7fd8263384855cdd900275e63ba2.jpg)
Good thing it's a practice project. I *think* it got better after I upped the air pressure, but it's hard to tell over the existing speckles, and I didn't want to waste too much on the butcher paper cause I didn't mix much.
![AEECA2B0-531F-405A-8FE5-69A7B0E048EC.jpeg AEECA2B0-531F-405A-8FE5-69A7B0E048EC.jpeg](https://vansairforce.net/data/attachments/11/11373-7bed7fd8263384855cdd900275e63ba2.jpg)
Good thing it's a practice project. I *think* it got better after I upped the air pressure, but it's hard to tell over the existing speckles, and I didn't want to waste too much on the butcher paper cause I didn't mix much.