VAF POSTS & RV NEWS THAT CAUGHT MY EYE.....dr:
—————————————————————————
First Flight! …markspsmith 8
https://vansairforce.net/threads/show-us-a-pic-of-your-finished-rv-8-8a.1740/page-19#post-1769400
Are you passing hot, crappy gas?
What is this canopy clip?
Finish Kit - orphan bits….-14
RV-12 N917PH new custom paint job by Fulltron …advertiser
Op63 (remote canopy release) and Section 59 (power module) …-14
OFF TOPIC:
PS: Older issues of the ‘VAF News’ can be found at:
—————————————————————————
First Flight! …markspsmith 8
https://vansairforce.net/threads/show-us-a-pic-of-your-finished-rv-8-8a.1740/page-19#post-1769400
Are you passing hot, crappy gas?
Are you passing hot, crappy gas?
Well I do at times........ Winter to summer mogas changeover season has always been a challenge - the winter mogas on a warm day would lead to some issues, like fuel boiling in the fuel line, and carb, leading to an over rich condition on take off with a corresponding stumble after a hot...
vansairforce.net
What is this canopy clip?
What is this canopy clip?
I have had my RV-12 for about two years now. I have been trying to figure out what this clip on the Roll Bar Frame assembly is for. I don't see it depicted on any of the numerous drawings I have.
vansairforce.net
Finish Kit - orphan bits….-14
Finish Kit - orphan bits.
I’m doing the inventory on my finish kit, but can’t identify where these parts are used? 2 plain aluminium machined blocks - AB3-3/4x1 1/2 x 1.188 - seems they should be used for something important with that specific dimension? A spacer for jigging something? Also - a long compression...
vansairforce.net
RV-12 N917PH new custom paint job by Fulltron …advertiser
RV-12 N917PH new custom paint job by Fulltron
Mike picked up his RV-12 this morning with N917PH's new custom paint job by Fulltron. For those RV-12 builders wondering if we paint 12's, the answer is yes, and Fulltron has several more RV-12's scheduled for painting in the near future. Next week we'll have another custom RV-7 paint job...
vansairforce.net
Op63 (remote canopy release) and Section 59 (power module) …-14
Op63 (remote canopy release) and Section 59 (power module)
I’m planning out where to put my remote canopy release handle, and I had initially thought the bottom of the power module would be a good spot. However, it seems my F-14188A Power module front plate is not the same as the one depicted in OP63? (It’s the same as in Section 59). It’s like the...
www.vansairforce.net
OFF TOPIC:
PS: Older issues of the ‘VAF News’ can be found at:
Doug's Area ....The VAF News & my flying resume.
Pushed out every now and then.
www.vansairforce.net