Dgamble
Well Known Member
I'm to the point where the aft bulkhead is done and we are supposed to test fit the Horz Stab to determine what washers to use for the best fit. The problem I'm having is that the AN12-4A bolts are too wide at the shank to fit through the holes in the brackets. I went back to the stab assembly pages to see if I had missed something about final drilling to some size, but couldn't find anything like that.
Any ideas?
Later: I succeeded in getting the brackets holes just a tad larger, but failed in finding the daggone delete button on this message.
Any ideas?
Later: I succeeded in getting the brackets holes just a tad larger, but failed in finding the daggone delete button on this message.
Last edited: