Finishing my RV4 with Flyboy pneumatic tire, fork etc. The pivot post weldment on the stinger is a 1999 vintage kit With grease zerk.
The tail wheel pivot has negative caster and the pivot is not vertical In the camber plain. I flew my RV3 with negative caster so I assume this is not a show stopper.
The bolt holes in the stinger are horizontal, so I propose the problems are in the pivot post weldment.
I can build a new weldment to correct both issues, but is there another solution ??
The tail wheel pivot has negative caster and the pivot is not vertical In the camber plain. I flew my RV3 with negative caster so I assume this is not a show stopper.
The bolt holes in the stinger are horizontal, so I propose the problems are in the pivot post weldment.
I can build a new weldment to correct both issues, but is there another solution ??