pilot28906
Well Known Member
I have the Bell fork and am assembling it with the tire, spring, etc. I have a couple questions:
1) What torque is used for the large nut that holds the yoke to the assembly?
2) On the bolt that goes through the wheel, is it OK to have 3 washers on one side of the wheel and 2 on the other side? Three will not fit on both sides without springing the yoke out. I tightened the castle nut and the yoke clamps the washers without them spinning.
3) Related to #2, how freely should the wheel spin? It rolls when I spin it by hand but only about one revolution before it stops. Want to make sure the nut isn't too tight or too loose.
Thanks,
1) What torque is used for the large nut that holds the yoke to the assembly?
2) On the bolt that goes through the wheel, is it OK to have 3 washers on one side of the wheel and 2 on the other side? Three will not fit on both sides without springing the yoke out. I tightened the castle nut and the yoke clamps the washers without them spinning.
3) Related to #2, how freely should the wheel spin? It rolls when I spin it by hand but only about one revolution before it stops. Want to make sure the nut isn't too tight or too loose.
Thanks,