Running through testing and a couple of questions to 12 ers.
Dynon Skyview - legacy install - 1 upload from Vans (2017)
Is there a way to display or record tacho hours rather than Hobbs ? Never used Hobbs, always Tacho hours but can't find it in the set up.
K Factor - we are indicating 10 gph which I think is a tad high !!! Does anyone have ballpark K Factor numbers for a standard red cube Rotax install please.
Re pitched the prop to pin 2 setting, will test this week and checking the skins for wing low. Other than that, all going swimmingly
Getting an annoying buzzing that is obvious on the YouTube vid. Cycles at 2 second intervals, coming out of the intercom as it disappears in ISO. We have run for 2.5 hours now so the Dynon back up battery won't be fully charged - any factor ?
Suggestions welcomed.
Dynon Skyview - legacy install - 1 upload from Vans (2017)
Is there a way to display or record tacho hours rather than Hobbs ? Never used Hobbs, always Tacho hours but can't find it in the set up.
K Factor - we are indicating 10 gph which I think is a tad high !!! Does anyone have ballpark K Factor numbers for a standard red cube Rotax install please.
Re pitched the prop to pin 2 setting, will test this week and checking the skins for wing low. Other than that, all going swimmingly
Getting an annoying buzzing that is obvious on the YouTube vid. Cycles at 2 second intervals, coming out of the intercom as it disappears in ISO. We have run for 2.5 hours now so the Dynon back up battery won't be fully charged - any factor ?
Suggestions welcomed.