WingnutWick
Well Known Member
Hello all,
Finishing up the install of the Dynon D-10 EMS and have everything nearly wired up except for the Tach. I've attached a pic of what I believe is the line used on my steam-gauge tach which runs into my cockpit. This has four wires (Red, Black, White, Brown) and all but the brown were used on my old tach. Looking at the Dynon instructions, is this considered a standard transducer? Should I just connect the red (I'm guessing) wire to the pin 32 using no resistor? What is the Brown wire for? Do the other wires need to go anywhere?
Thanks all!
Wingnut
Finishing up the install of the Dynon D-10 EMS and have everything nearly wired up except for the Tach. I've attached a pic of what I believe is the line used on my steam-gauge tach which runs into my cockpit. This has four wires (Red, Black, White, Brown) and all but the brown were used on my old tach. Looking at the Dynon instructions, is this considered a standard transducer? Should I just connect the red (I'm guessing) wire to the pin 32 using no resistor? What is the Brown wire for? Do the other wires need to go anywhere?
Thanks all!
Wingnut