John Courte
Well Known Member
Hi,
I'm looking for a drawing or measurements for the bottom of the Superior Cold Air horizontal induction sump, in particular, the bolt pattern of the bracket mount bosses so I can fabricate cable attach brackets for my AFP throttle and mixture cables.
I'm not the most well-versed in mechanical engineering or fabrication, and the difficulty I'm having is getting the bolt pattern onto a template with an acceptable degree of accuracy.
I'm looking to build something similar to Brian Carroll's setup, pictured in this thread:
http://www.vansairforce.com/community/showthread.php?t=66232&highlight=afp+superior+bracket
Unlike Brian, I'm still squaring off in a cage match with the Van's snorkel.
Thanks,
-John
I'm looking for a drawing or measurements for the bottom of the Superior Cold Air horizontal induction sump, in particular, the bolt pattern of the bracket mount bosses so I can fabricate cable attach brackets for my AFP throttle and mixture cables.
I'm not the most well-versed in mechanical engineering or fabrication, and the difficulty I'm having is getting the bolt pattern onto a template with an acceptable degree of accuracy.
I'm looking to build something similar to Brian Carroll's setup, pictured in this thread:
http://www.vansairforce.com/community/showthread.php?t=66232&highlight=afp+superior+bracket
Unlike Brian, I'm still squaring off in a cage match with the Van's snorkel.
Thanks,
-John