So I ran my Whelen strobe cable from each wing root thru the wire run holes in the seat ribs just aft of the spar. Halfway thru the cable has to pass by the aluminum bracket which bolts to the spar for the contol stick mounts. It rubs against the stick mount. Is there a better way to route this cable from the wing root to the power supply behind the baggage bulkhead or is there a good way to buffer the cable against abrasion from the bracket? (this is the 3+1 gray shielded cable for high volts). I'm just not sure if this is the correct routing but I see no other as the seat pans and baggage floor are riveted... Appreciate any suggestions! Thanks, Jim