Reference - Section 36, Page 10 - Figure 1.
The 1/4" hole in the CS-00008 for cable routing seems to be in the "wrong" place.
After looking at the stick "in situ", the pivot point, the surrounding structure - it seems like a better place for the stick wiring to exit from the stick is on the same side as the molex connector "flange" in the CS-00007 base.
What am I missing here?
The 1/4" hole in the CS-00008 for cable routing seems to be in the "wrong" place.
After looking at the stick "in situ", the pivot point, the surrounding structure - it seems like a better place for the stick wiring to exit from the stick is on the same side as the molex connector "flange" in the CS-00007 base.
What am I missing here?