RE:Forum Search

Hi Jay

Do a forum search with "stewart paint" and you will get alot of great info. Plus if you haven't already seen Stewarts training videos on youtube...check them out at......

http://www.youtube.com/stewartsystems

I have used both there primer and two part poly....but would I use it again???
I will need to get back to you later on that!!!!!:eek:

Frank @ 1L8 ...RV7A... Flying and Tracken with MT-RTG
 
I used Stewart Systems etching wash, primer, and paint on my RV-9A. Yes, I would use it again. I had to experiment more than I liked to get my fluid flow numbers right for my gun (a high quality IWATA), but the results turned out pretty good, and I often get positive comments on my paint job.

It was really great to clean the gun in the laundry sink. You must have humidity below about 70%, and temperature above 70 degrees.

Let me know if you have questions.

Neal Powell
[email protected]

RV-9A
Flying sweet!
 
You must log in or register to reply here.