rgmiller1974
Member
Hello Everyone,
I'm getting ready to start the main gear installation on my RV-8 QB and I'm curious about all the steel parts (U-801 through U-806). In my kit, they were powder coated except for the surfaces that will mate together. It's clear these surfaces were deliberately masked off, and I'm wondering if I'm expected to prime them myself. Leaving them bare seems like asking for trouble later on, but I didn't see this mentioned specifically in the manual or here in the forums.
Thanks,
-Ross Miller
I'm getting ready to start the main gear installation on my RV-8 QB and I'm curious about all the steel parts (U-801 through U-806). In my kit, they were powder coated except for the surfaces that will mate together. It's clear these surfaces were deliberately masked off, and I'm wondering if I'm expected to prime them myself. Leaving them bare seems like asking for trouble later on, but I didn't see this mentioned specifically in the manual or here in the forums.
Thanks,
-Ross Miller