[Stockmanreef]

I plan to build an RV-10. I plan to use the 3060 squeezer from Numatx, so that I can use it to squeeze rivets and then mount it to a C-frame for dimpling.

Which squeezer yokes will I need for the job?

Thanks
ken

 

[CharlieWaffles]

For my RV-10 I used two yokes and was able to do just about everything I needed to.

3" Yoke
http://www.averytools.com/prodinfo.asp?number=7740

Longeron Yoke
http://www.averytools.com/prodinfo.asp?number=7755

There were a few times a 4" yoke would have been helpful, but not enough to buy. Also I borrow a No Hole (http://www.averytools.com/prodinfo.asp?number=7745) a few times as well, but not often enough to buy.

 

[Rupester]

Three yokes seems to be the ticket ...

Like Charlie said, the basic 3" and longeron yokes are musts. if you don't have someone close by to borrow yokes from, a 4" no-hole yoke will save yer butt in numerous instances.

 

[NovaBandit]

Ditto on the 3" and Longeron.

That being said, I really like my 4" no-hole yoke. And when I'm done with my project, I'll sell it for a good percentage of what I bought it for. Think of it as a long term rental!