K?hler
Active Member
I'm ready to buy yokes for my CP-214. I'm planning on a longeron yoke and a no-hole yoke. I also plan to get the adjustable set holder.
For the no-hole yoke, is a 4" really useful? Where is it used and how much? If that depth is only needed for 6 rivets maybe I'll just get a shallower one rather than haul that big chunk of iron around. (also concerned that set holder won't work with heavier base on a 4".) I haven't begun building so I'm not sure where there might be a bunch of rivets that are between 2.5 and 4 inches of the edge. Seems like they're either real close to the edge or real far away.
For the no-hole yoke, is a 4" really useful? Where is it used and how much? If that depth is only needed for 6 rivets maybe I'll just get a shallower one rather than haul that big chunk of iron around. (also concerned that set holder won't work with heavier base on a 4".) I haven't begun building so I'm not sure where there might be a bunch of rivets that are between 2.5 and 4 inches of the edge. Seems like they're either real close to the edge or real far away.