Almost complete with the annual and yet another item has popped up. Using the spar pin gauge it fits fine in all the hole but on the left wing inner pin when I turn the gauge 360 degrees in the hole it catches a bit (out of round) but never goes below the gauge step. Is this a pass or a fail for anyone experiencing this? Since the wing to fuselage strip was added it has become almost an act of the lord to get the pins to fit. So for the last two years since installing the strip we have pounded, rocked, and used a wooden dowel to get the pins to finally get in. I think this may have distorted the bushing a bit. So again my question is, does it still pass if the gauges never goes below the gauge step? It’s super tight but gets tighter in one area when spinning the gauge 360 degrees. Also if I have to replace the bushing, anybody done this and can shed some insight how to do it? Thanks in advance