Av8torTom Well Known Member Oct 1, 2015 #1 I'm fabricating the C-621 and C-622 (Drawing 47) canopy release links, and looking for techniques to make the 1/16 and 1/8" slots at each end. So far I'm not get satisfactory results with a band saw. Anyone have suggestions? Thanks, Tom
I'm fabricating the C-621 and C-622 (Drawing 47) canopy release links, and looking for techniques to make the 1/16 and 1/8" slots at each end. So far I'm not get satisfactory results with a band saw. Anyone have suggestions? Thanks, Tom
bruceh Well Known Member Friend Oct 1, 2015 #2 Get the thin cut dremel wheels. Once you have a decent gap, you can get a jeweler's file in there to widen the slots as needed.
Get the thin cut dremel wheels. Once you have a decent gap, you can get a jeweler's file in there to widen the slots as needed.