flydjd
Well Known Member
Hi all,
I have just spent 3 hours forlornly looking for an answer but am wasting precious building time so here goes.....
From Dwg's 24, 41 & 42 it appears that the fwd end plate of the WD-643-22 canopy brace fits between the port side of the F-7108A fuselage rib and the F-7108B angle BUT this would result in the F-7108B angle sitting proud of the rib.....
Are you expected to remove material from the back of the angle so that it sits flush ? I cannot find any reference to this in the instructions (unless it comes later under canopy fitting)
Help please
I have just spent 3 hours forlornly looking for an answer but am wasting precious building time so here goes.....
From Dwg's 24, 41 & 42 it appears that the fwd end plate of the WD-643-22 canopy brace fits between the port side of the F-7108A fuselage rib and the F-7108B angle BUT this would result in the F-7108B angle sitting proud of the rib.....
Are you expected to remove material from the back of the angle so that it sits flush ? I cannot find any reference to this in the instructions (unless it comes later under canopy fitting)
Help please