RONSIM

RONSIM

Well Known Member
Just given a used (but good) Slick Start, SS1001, Rev D --- Would like to put it on the RV-10, IO540C4B5 with Slick Mags, 6393, 6350 (no impulse on either). Standard key switch (Lft, Rt, Both, Start)

I think? the wiring is Pin 1 to "P" lead on left mag, Pin 4 to switched side of starter relay, and Pin 5 to ground.

I would appreciate your help to ensure I do not do something dumber than usual.

Thanks,

Ron
 
Bob, thanks

I believe from the link you sent me, I should be able to wire the way I mentioned and it should work --- will give it a try ---- certainly hope it takes care of the "hot" start problem.
 
You must log in or register to reply here.