I've finished the wiring and installation of the Skyview and all of the avionics. I still have the wings and tail off, as I am working in my basement. I would like to see if the electronics work before moving to the hangar.
On power up with the Master Switch, I get no smoke, and the Skyview goes through console boot. Then I get three full page X's across the screen with the following failures:
ADAHRS FAIL: NO GPS POSITION SOURCE: EMS FAIL
Warning indicator is lit. When I press the button associated with the warning light it says ADAHARS FAIL and TRANSPONDER FAIL
Also, in a small block it says: MAP Trial mode, 30 hours remaining
Where do I go from here? IT must be a setup issue. I can't believe nothing works. I am looking for somewhere to start here. Did I miss some documentation that I need to follow?
Hope to tap into some RV-12 Skyview talent here. Thanks in advance
Tom
On power up with the Master Switch, I get no smoke, and the Skyview goes through console boot. Then I get three full page X's across the screen with the following failures:
ADAHRS FAIL: NO GPS POSITION SOURCE: EMS FAIL
Warning indicator is lit. When I press the button associated with the warning light it says ADAHARS FAIL and TRANSPONDER FAIL
Also, in a small block it says: MAP Trial mode, 30 hours remaining
Where do I go from here? IT must be a setup issue. I can't believe nothing works. I am looking for somewhere to start here. Did I miss some documentation that I need to follow?
Hope to tap into some RV-12 Skyview talent here. Thanks in advance
Tom