I am doing a Skyview Conversion, Step 5 and Figure 2 on page 42D-20 were initially very confusing to me. Here are some notes I made after figuring this out.
This part of the conversion requires wiring harnesses WH-00026 and WH-00026 Rev-1 Kit (also known as Fix-1) supplied in the Skyview Conversion Avionics Kit.
On the left side of Figure 2, I labeled RZ942 and RZ943 as wires in the WH-00026 Rev-1 Kit. On the right side of Figure 2, I labeled RZ194 as the Pilot Headset Harness, and RZ195 as the Co-Pilot Headset Harness. Also on the right side, RZ944 is in the WH-00026 Rev-1 Kit.
I then cut off the male pins from the Pilot and Co-Pilot Headset Harnesses and spliced on the WH-00026 Rev-1 wires as shown in Figure 2.
At the top of Figure 2, I labeled the "OPTIONS" and "AUTOPILOT" connectors with "REAR VIEW/PIN INSERTION SIDE."
I then removed the backshells from the OPTIONS and AUTOPILOT connectors, inserted the pins from RZ941, RZ942, RZ943, RZ944, and reinstalled the backshells.
This part of the conversion requires wiring harnesses WH-00026 and WH-00026 Rev-1 Kit (also known as Fix-1) supplied in the Skyview Conversion Avionics Kit.
On the left side of Figure 2, I labeled RZ942 and RZ943 as wires in the WH-00026 Rev-1 Kit. On the right side of Figure 2, I labeled RZ194 as the Pilot Headset Harness, and RZ195 as the Co-Pilot Headset Harness. Also on the right side, RZ944 is in the WH-00026 Rev-1 Kit.
I then cut off the male pins from the Pilot and Co-Pilot Headset Harnesses and spliced on the WH-00026 Rev-1 wires as shown in Figure 2.
At the top of Figure 2, I labeled the "OPTIONS" and "AUTOPILOT" connectors with "REAR VIEW/PIN INSERTION SIDE."
I then removed the backshells from the OPTIONS and AUTOPILOT connectors, inserted the pins from RZ941, RZ942, RZ943, RZ944, and reinstalled the backshells.