Anyone know what specific size and type of o-rings the Sioux 3X rivet gun uses? The three identical ones inside the trigger assembly that is...
My gun was leaking air and it turns out these o-rings are shredded. I measured them and they appear to be 0.07" thk by .562" OD but it's really hard to get an accurate measurement. I'm also assuming they're buna N? I ask because I might have some at work that I can use, rather than wait to get them in the mail...
The VAF member I bought this from claimed it worked fine for him, seems unlikely given the damage. So that's nice...
ETA:
Parts list says .438IDx.063" for $2.80 each, no material listed.
My gun was leaking air and it turns out these o-rings are shredded. I measured them and they appear to be 0.07" thk by .562" OD but it's really hard to get an accurate measurement. I'm also assuming they're buna N? I ask because I might have some at work that I can use, rather than wait to get them in the mail...
The VAF member I bought this from claimed it worked fine for him, seems unlikely given the damage. So that's nice...
ETA:
Parts list says .438IDx.063" for $2.80 each, no material listed.
Last edited: