Folks,
I have been working on this for awhile, and I think I about have it done. What it is, is a simple plug and play interconnect board to connect two SkyView screens, and using simple harnesses to connect your Transponder, ADSB Receiver, GPS Receiver, two extra easy accesses to Serial 3 and 4, 5 port SkyView bus, with three axis Autopilot connectors on the hub. This is a pretty small hub. Board is 5” X 5” and in the mount, it is 5 1/2” X 6 1/2”.
It is a simple install. Mount the hub, connect the power harness to your circuit breakers, and the rest is to make simple harnesses for each module, and plug into the board, program the screen, and you are basically done.
What I am looking for, is there any interest in something like this to connect your Dynon SkyView system? Even though I have not figured out a price, but it might be somewhere around $300 for the board only assembled, but I could make it as a kit for you DIY’er if interested.
Email me at [email protected] if interested.
Brian
I have been working on this for awhile, and I think I about have it done. What it is, is a simple plug and play interconnect board to connect two SkyView screens, and using simple harnesses to connect your Transponder, ADSB Receiver, GPS Receiver, two extra easy accesses to Serial 3 and 4, 5 port SkyView bus, with three axis Autopilot connectors on the hub. This is a pretty small hub. Board is 5” X 5” and in the mount, it is 5 1/2” X 6 1/2”.
It is a simple install. Mount the hub, connect the power harness to your circuit breakers, and the rest is to make simple harnesses for each module, and plug into the board, program the screen, and you are basically done.
What I am looking for, is there any interest in something like this to connect your Dynon SkyView system? Even though I have not figured out a price, but it might be somewhere around $300 for the board only assembled, but I could make it as a kit for you DIY’er if interested.
Email me at [email protected] if interested.
Brian
Last edited: