[terrye]

There are two file formats that you can download from Vans, DXF or IGES. In either case you end up with the outline shape only, not a parametric model. If you have created a .SLDPRT Solidworks Part, then all you have to do is create an Extruded Boss/Base to make the extension you want. I would create it across the bottom straight edge so that you can make the 90 degree bottom flange in one operation.

 

[Archie167]

There are two file formats that you can download from Vans, DXF or IGES. In either case you end up with the outline shape only, not a parametric model. If you have created a .SLDPRT Solidworks Part, then all you have to do is create an Extruded Boss/Base to make the extension you want. I would create it across the bottom straight edge so that you can make the 90 degree bottom flange in one operation.

Thanks, I’ll give that a try!

 

[jaradtke]

My first try at custom fiberglass work came out better than I hoped.
Inspired by Laird Owens design and Dan Horton amazing fiberglass work.

 

[Davea320]

This is my latest

 

[Clayvt]

My panel came in today from Advanced Flight Systems.
I went single Dynon screen for now. To save a bit I picked up a used 430 from here earlier this year for my nav/comm/gps.

Wish I had known they were coming out with the remote gps navigator. Would have altered my layout a bit.

Behind the panel is their ACM and wire harnesses.
The clock came from my late grandfathers Grumman Yankee that sadly got donated to an A&P school cause it was too far gone.

 

[rockyfatcat]

Still some work to do