There are tons of books that I could recommend. Here are the top several:
- There's a set of 4 books by
Tony Bingelis. Get all four.
http://www.buildersbooks.com/bingelis_set_of_4.htm Some of it is slightly dated at this point, but Bingelis was a god in the homebuilt scene and his words live on. What is dated will be updated by seeing stuff like the countless builder web sites out there, and...
-
AeroElectric Connection --
http://www.aeroelectric.com Buy a copy and read Bob Nuckolls' fantastic book on aircraft electrical systems. Bob actually holds semi-hands-on workshops around the country as well. At a minimum read the book. His site also has
reference articles which are a veritable goldmine. (If you're already buying from
Builder's Bookstore you can get it there:
http://www.buildersbooks.com/aeroelectric_connection.htm)
-
http://www.buildersbooks.com/4313_ap.htm This is the bible. Every builder/mechanic needs a copy. I have an electronic copy that I could probably send you, in case you want to save the bucks, but I like having a printed copy personally, for the shop.
-
http://www.buildersbooks.com/aircraft_handbook.htm This is a good one to have. It talks about hardware identification and stuff like that. Alternatively, get a copy of
Aircraft Spruce's catalog (free) and peruse the airframe and hardware sections. I can't say much about Spruce's tool kits, but their catalog is actually a terrific reference!
- Don't know if you've been following the whole "
Build Your Skills" series I've been writing for
Kitplanes magazine, but if not (and maybe in addition), this book is a great source of info on sheet metal standards and techniques:
http://www.buildersbooks.com/aircraft_sheet_metal.htm
- This book is full of strictly
RV-specific tips and tricks:
http://www.buildersbooks.com/24_years_of_the_rvator_vans_.htm Great stuff! Best to read it before you build, otherwise you just end up looking back and saying, Doh! I shoulda done that!
That's a pretty meaty start as far as a book list is concerned. I hope that helps.