G glenn654 Well Known Member Jul 2, 2014 #1 Is there someone out there who can sharpen Unibits? Glenn Wilkinson
R rvsxer Well Known Member Jul 3, 2014 #2 I've had very good luck using a pencil grinder (or a Dremel tool) with a 1/8" rotary file. Always file the INSIDE of the cutting surface. If you file the outside diameter the bit is scrap.
I've had very good luck using a pencil grinder (or a Dremel tool) with a 1/8" rotary file. Always file the INSIDE of the cutting surface. If you file the outside diameter the bit is scrap.