Looking at this part of the plans, and trying a measuring tape at first, I found it difficult to get consistent measurements solo.
So I came up with what may or may not be a unique solution. I took a piece of wire and crimped a ring connector on it, then secured it to the center forward rivet hole and measured the distance and made adjustments. I was careful to twist the connector to point in the correct direction.
Connector/wire:
Using small piece of tape to mark exact position at each corner:
So I came up with what may or may not be a unique solution. I took a piece of wire and crimped a ring connector on it, then secured it to the center forward rivet hole and measured the distance and made adjustments. I was careful to twist the connector to point in the correct direction.
Connector/wire:
![IMG_0156.jpeg](/community/proxy.php?image=https%3A%2F%2F1.bp.blogspot.com%2F-Ga5x2rQD9p8%2FX1bmjqYBbMI%2FAAAAAAAAI7I%2F0RWMaLrRlpYZiatXmwB0raY1zBXGyY73ACLcBGAsYHQ%2Fs2048%2FIMG_0156.jpeg&hash=35299b53deba9037b0c6346ff0eaf857)
Using small piece of tape to mark exact position at each corner:
![IMG_0157.jpeg](/community/proxy.php?image=https%3A%2F%2F1.bp.blogspot.com%2F-Gyy4l69sASY%2FX1bmkEGpEvI%2FAAAAAAAAI7M%2Fyr7To6RNl1It_fl1hylYPwA4o8hFD7i0ACLcBGAsYHQ%2Fs2048%2FIMG_0157.jpeg&hash=4b34b492495d63f4823e025c996cf4e6)
![IMG_0159.jpeg](/community/proxy.php?image=https%3A%2F%2F1.bp.blogspot.com%2F-81XABXAAQSg%2FX1bmke6K5EI%2FAAAAAAAAI7U%2FuVMnj8vgMosHrZ5hVtO06nZfa2puWgKSgCLcBGAsYHQ%2Fs2048%2FIMG_0159.jpeg&hash=ed21f32f1cd575449a3aa441087dff32)
Attachments
Last edited: