My fuselage kit came with the FT-60 fuel flow metering device. The VA-188 mounting bracket has holes drilled for the mounting bolts but page 22-04 does not show the hardware for the FT-60. It mounts with AN-4 bolts to the two larger holes. My hardware kit does not include the bolts or the nutplates which look to be some sort of minature type and -4 for 1/4x28, not the K1000-3 shown.
I am sure Van's will send the hardware when I call tomorrow but the point of the thread is that if one installs the hardware shown on page 22-04 and then you find later that you have the FT-60, you will have to remove the bracket and change the hardware.
I also checked for revisions of this page and found none.
I searched the forum and was surprised no one else has reported this. Am I the only one to get the FT-60?
Tony
I am sure Van's will send the hardware when I call tomorrow but the point of the thread is that if one installs the hardware shown on page 22-04 and then you find later that you have the FT-60, you will have to remove the bracket and change the hardware.
I also checked for revisions of this page and found none.
I searched the forum and was surprised no one else has reported this. Am I the only one to get the FT-60?
Tony