tim walter
Well Known Member
in section 21 page 3 figure 2
the diagram shows 3 nutplates along the F-1206A flange on each side
with text that says "2x" instead of "3x" even though there are clearly 3 nutplates, and 3 arrows from the "2x" text.
Is this a mistake in the plans?
Also, it shows diffferent nutplate part numbers for left and right sides.
right sides are K1100-08, left sides are k1000-08
is that also correct?
both sides were match drilled with #19 as directed in the plans, so why have different nut plates?
the diagram shows 3 nutplates along the F-1206A flange on each side
with text that says "2x" instead of "3x" even though there are clearly 3 nutplates, and 3 arrows from the "2x" text.
Is this a mistake in the plans?
Also, it shows diffferent nutplate part numbers for left and right sides.
right sides are K1100-08, left sides are k1000-08
is that also correct?
both sides were match drilled with #19 as directed in the plans, so why have different nut plates?