Bayou Bert
Well Known Member
I have tried to find info on this subject and have drawn a blank.
I have Classic Aero interior. Yesterday I was trying out different
seating arrangements and when I move the back of the seat to the most aft
hinge point, the bottom of the seat back hits the two attach points.
I have Crow harnesses and I have the point bolted in place angled
toward the lap area. The seat is hitting the Crow attach point where
it bolts to the Vans points. Keeps the seat from flopping back against
the cross member.
Can one just bend the attach points out? I need about 1" on each side.
Or is there something else I can do?
Thanks for any help here.
I have Classic Aero interior. Yesterday I was trying out different
seating arrangements and when I move the back of the seat to the most aft
hinge point, the bottom of the seat back hits the two attach points.
I have Crow harnesses and I have the point bolted in place angled
toward the lap area. The seat is hitting the Crow attach point where
it bolts to the Vans points. Keeps the seat from flopping back against
the cross member.
Can one just bend the attach points out? I need about 1" on each side.
Or is there something else I can do?
Thanks for any help here.