I'm putting in a SD-8 alt and am not sure where to place the hall effect sensor for current sensing (AFS) on the output wire?
1. Should the output wire straight from the SD-8 run through the hall effect ring? the one that wires directly to the capacitor?
2. put it on the main output wire from the SD-8 system relay that ties to the electrical buss?
Seems that if it were #2 one would never be sure the SD-8 was producing power until you absolutely needed it.
Thanks for the help...
RV-7 IO-375 engine hung running the spaghetti....
1. Should the output wire straight from the SD-8 run through the hall effect ring? the one that wires directly to the capacitor?
2. put it on the main output wire from the SD-8 system relay that ties to the electrical buss?
Seems that if it were #2 one would never be sure the SD-8 was producing power until you absolutely needed it.
Thanks for the help...
RV-7 IO-375 engine hung running the spaghetti....