Bernie Knight
Member
Hi all,
After purchasing an RV8 with a custom race car type carbon fibre seat I am finding I am sitting quite high and forward.
The seat attaches to the rear frame support for the stock metal seat back. It's then mounted on a custom seat bracket at the front holding it up about 3".
I am considering removing this race seat and placing the back seat panel back in and cushion.
I will need to make/ fabricate a new seat back panel. I have found photos of this panel.
I've searched the Forum for photos of the standard seat back and seat base.
Is there a seat base or do the base cushions just sit on the floor? How is the seat back attached to the support frame and floor area. Riveted, screws etc ?
Sorry about all the questions, but I don't want to re invent the wheel.
Any photos of this particular seat back attachment, cushions etc would be appreciated.
If its easier to just email photos..
[email protected]
Thanks.
After purchasing an RV8 with a custom race car type carbon fibre seat I am finding I am sitting quite high and forward.
The seat attaches to the rear frame support for the stock metal seat back. It's then mounted on a custom seat bracket at the front holding it up about 3".
I am considering removing this race seat and placing the back seat panel back in and cushion.
I will need to make/ fabricate a new seat back panel. I have found photos of this panel.
I've searched the Forum for photos of the standard seat back and seat base.
Is there a seat base or do the base cushions just sit on the floor? How is the seat back attached to the support frame and floor area. Riveted, screws etc ?
Sorry about all the questions, but I don't want to re invent the wheel.
Any photos of this particular seat back attachment, cushions etc would be appreciated.
If its easier to just email photos..
[email protected]
Thanks.
Last edited: