A A5555 Well Known Member May 27, 2012 #1 Fit two 5702-60-75 washers per side (total 4) to control tie rod. Is there a concern for added bolt stress with this spacing?
Fit two 5702-60-75 washers per side (total 4) to control tie rod. Is there a concern for added bolt stress with this spacing?
mikehoover Well Known Member May 27, 2012 #2 DWG 38, DETAIL B shows one 5702-75-60 washer on either side of the rod end bearing.
A A5555 Well Known Member May 27, 2012 #3 this is free state, two per side this is free state, two per side, should I just install one per side and clamp it with bolt?
this is free state, two per side this is free state, two per side, should I just install one per side and clamp it with bolt?
bruceh Well Known Member Friend May 27, 2012 #4 I think I had to draw the sides of the weldment in tighter with the bolt when I put the washer on each side of the rod end bearing.
I think I had to draw the sides of the weldment in tighter with the bolt when I put the washer on each side of the rod end bearing.
A A5555 Well Known Member May 28, 2012 #5 thx Bruce I also sent this question off to Vans. BTW I use your good website for ideas. thanks for making such a nice website. Last edited: May 28, 2012
thx Bruce I also sent this question off to Vans. BTW I use your good website for ideas. thanks for making such a nice website.