[Jrskygod]

Can someone tell me the station numbers or measurement from datum for the wigwag and for the panel? Are they shown on the plans as I could not find them.

 

[whd721]

The panel face is at 76.75".

Note: the actual panel CG is 1-3 inches forward depending of the avionics installed.

Wigwag? type? Power supply type and location?

 

[Jrskygod]

wig wag is the elevator bellcrank assembly

 

[whd721]

The "wigwag" elevator hinge point is at about 224.5". The aft of my fuselage is stuffed back into a corner and difficult to reach.

Take a blue masking tape and run it along the fuselage longeron from front to back. The LE on the wing is at 70" by definition. Mark off any point square to the longeron and write it on the tape for future use.

Note: the CG of the elevator is also not at the hinge point, it is 1-2 inches aft.

calculating a W&B is difficult at best.