O oceanbird Member Jun 28, 2007 #1 Hello, I have been reading these forums for a few months, learning a lot and really enjoying. Last edited: Mar 15, 2010
A apatti Well Known Member Jun 28, 2007 #2 Perhaps you could try using several spring clamps to hold the bulkheads together as you drill and rivet the holes that connect them to one another. Also, remember that the pre-punched skin will end up locating the flanges of the bulkheads in their proper positions. I hope this helps.
Perhaps you could try using several spring clamps to hold the bulkheads together as you drill and rivet the holes that connect them to one another. Also, remember that the pre-punched skin will end up locating the flanges of the bulkheads in their proper positions. I hope this helps.
briand Well Known Member Jun 30, 2007 #4 Mine might have been a tiny bit better than that. However, I think yours are good enough. Build on.