mackd
Active Member
Today, I dimpled the screw holes in my trim servo stiffener and access plate for the left rudder. I used the #6 screw dimple dies that came with my Avery kit in my pneumatic squeezer. When I try to fit the access plate over the stiffener, however, it won't sit flush in the vicinity of the screw holes and I end up with a small gap. It looks to me like the dimple in the stiffener isn't deep enough to accept the dimple on the access plate.
I'm pretty sure I have the squeezer set properly and I don't see how I could get the hole dimpled any more. Has anyone else seen this and have a suggestion?
Thanks.
I'm pretty sure I have the squeezer set properly and I don't see how I could get the hole dimpled any more. Has anyone else seen this and have a suggestion?
Thanks.