Ran into a tight rivet situation when working on riveting the platenuts to the Z brackets on the RV 7 wing. My tanks were built by Evans aviation. Looking to see how others completed this task. I might have to end up 1.) modifying my squeezer yoke 2.) buy a smaller yoke 3.) modify squeezer flush set 4.) new/modify bucking bar.
Suggestions? Thoughts?
http://s44.photobucket.com/user/phibbs76/media/2014-10-12134413_zpsb2da7b97.jpg.html
http://s44.photobucket.com/user/phibbs76/media/2014-10-12134319_zpsdd702f3c.jpg.html
http://s44.photobucket.com/user/phibbs76/media/2014-10-12134423_zps5b106b42.jpg.html
Suggestions? Thoughts?
http://s44.photobucket.com/user/phibbs76/media/2014-10-12134413_zpsb2da7b97.jpg.html
http://s44.photobucket.com/user/phibbs76/media/2014-10-12134319_zpsdd702f3c.jpg.html
http://s44.photobucket.com/user/phibbs76/media/2014-10-12134423_zps5b106b42.jpg.html