Hi folks,
Please see message below sent to Vans help line. I still await a reply but it is the weekend. Appreciate if you don't all fall about laughing but any thoughts appreciated.
"If it?s possible to make a mistake it seems I?ll find the way.
When drilling the centre section and the F-1204CL-R for the F-1204R retainer blocks (drill size #11) I picked up a packet out my drill drawer which was labelled DB 11. I merrily drilled the required holes. Next day I noticed the drill labelled DB 11 is in fact a ?? drill, i.e., the holes are too large.
Looking at the F-1204R retainer blocks, can I drill these holes out to ?? and use AN4-12A bolts? If not, is there another solution? Lesson learned to triple check things in future."
Jim D
Please see message below sent to Vans help line. I still await a reply but it is the weekend. Appreciate if you don't all fall about laughing but any thoughts appreciated.
"If it?s possible to make a mistake it seems I?ll find the way.
When drilling the centre section and the F-1204CL-R for the F-1204R retainer blocks (drill size #11) I picked up a packet out my drill drawer which was labelled DB 11. I merrily drilled the required holes. Next day I noticed the drill labelled DB 11 is in fact a ?? drill, i.e., the holes are too large.
Looking at the F-1204R retainer blocks, can I drill these holes out to ?? and use AN4-12A bolts? If not, is there another solution? Lesson learned to triple check things in future."
Jim D