alpinelakespilot2000
Well Known Member
For some reason on the 9 plans, the instructions don't have you fabricate and install the rudder travel stops until the VS and rudder is fitted. However, is there any reason not to drill and attach them now before the tailcone gets riveted together? It would seem that would solve two issues:
1. Rather than using CS-4s for the forward rivets to hold stop on the tailcone I could use solid 426's; and,
2. More importantly, it would allow me to debur those #30 holes that I'll be drilling through the tailcone skins and stringer.
Any problems with doing it now?
1. Rather than using CS-4s for the forward rivets to hold stop on the tailcone I could use solid 426's; and,
2. More importantly, it would allow me to debur those #30 holes that I'll be drilling through the tailcone skins and stringer.
Any problems with doing it now?