Gregg Brightwell
Well Known Member
Ok.... I knocked the Horizontal out in about 75 hrs. I finished the vertical, ('cept for the cap) in about 20 hrs.
Now I am on the Rudder.... dead stop. Apparently, in VAN's attempt to 'update their instructions / prints', they removed a few of the sketches from the instructions, and did not add them back into the prints. The instructions say to reference 'sketch 6-4-1' ( i think it was) to get spacing / location for the 5/8" angle that makes the rudder stiffeners. BUT, I don't have it.... ANYWHERE. I spent about 3 hrs, searching every piece of paper they sent me.
Anyone have the sketches? numbers? location?
Any help would be SUPER......
Dennis B, if you read this, thanks for looking for yours!
Gregg J. Brightwell
RV-4 emp. (bout to order wings)
Independence, KS
Now I am on the Rudder.... dead stop. Apparently, in VAN's attempt to 'update their instructions / prints', they removed a few of the sketches from the instructions, and did not add them back into the prints. The instructions say to reference 'sketch 6-4-1' ( i think it was) to get spacing / location for the 5/8" angle that makes the rudder stiffeners. BUT, I don't have it.... ANYWHERE. I spent about 3 hrs, searching every piece of paper they sent me.
Anyone have the sketches? numbers? location?
Any help would be SUPER......
Dennis B, if you read this, thanks for looking for yours!
Gregg J. Brightwell
RV-4 emp. (bout to order wings)
Independence, KS
