rv12builder
Member
Hi All,
I am trial fitting the rudder spar to the vertical stab and the directions call for using AN960-10 and/or 10L washers to set the appropriate clearance but do not specify what that is. Should it fit with no vertical play at all? Any suggestions?
Also, in setting the clearances should I tighten the bolt/nut to the appropriate torque setting?
Thanks.
Dave Jablon
RV 12 - Empennage Kit Started
I am trial fitting the rudder spar to the vertical stab and the directions call for using AN960-10 and/or 10L washers to set the appropriate clearance but do not specify what that is. Should it fit with no vertical play at all? Any suggestions?
Also, in setting the clearances should I tighten the bolt/nut to the appropriate torque setting?
Thanks.
Dave Jablon
RV 12 - Empennage Kit Started