Roll Swaging

A roll swaging machine is normally used to do this. It's a relatively expensive specialist tool.
 
Last edited:
Thanks do you happen to know the name of the little ball ends for the cables. I am trying to get new ones ordered
 
Those are the ones I ordered but they don’t fit. The shanks are too large even with the correct cable size. I have a call into vans
 
The shank will reduce in diameter when swaged. The spec is in AC43.13-1B page 7-31 e.g. for 1/8 cable the shank diameter after swaging is 0.219 and before swaging is 0.250.
Is there a big discrepancy between the part you ordered and the existing ball?
 
Last edited:
Yes way different but I just got off the phone with tech and he found the dwg and it called out those as the part number so off to get them done tomorrow. Thanks
 
You must log in or register to reply here.