OK, I put a shaft through the cable bulkhead hole to show the line the cable should take(see pic), looks to be a perfect interference with the elev trim lever, any thoughts on what to do here?
It is awkward but with judicious placement it can be made to work.
is representative of a few others on cockpit / panel section of my blog.
This is shown with no Trim Control however it comes down at a slight angle when fitted - about 10 degrees. The rudder cable hole / fairlead positioning has been dropped down a bit from the plans as well. They are close but wont foul.
Mine is run through a section of nylon tubing inboard of the trim mechanism. The nylon tubing continues aft to the bulkhead and prevents chafe/interference.