After final fit of rudder I have fabricated 1 and a half inch rudder links (F-6119) and my rudders are placed in the mid position. When the rudder is at full extention Left or Right, the rearward pedal rises to such a height that causes the rudder cable to bind in the snap bushing closest to it.The centre line of the bushing and the cable line up OK when rudder is centralised, but when the rudder pedal moves aft the cable moves well above the line of the snap bushing.
At present, when the pedals are fully aft, the start of the clevis on the cable just enters the snap bushing. The only threads I can find suggest placing tube on the cable, but this still has the clevis much higher than the bushing.
Is there another solution to this problem? Thanks
At present, when the pedals are fully aft, the start of the clevis on the cable just enters the snap bushing. The only threads I can find suggest placing tube on the cable, but this still has the clevis much higher than the bushing.
Is there another solution to this problem? Thanks