Hi all,
I bought a Rolo-Flair when I was making my fuel tanks. Seemed to work fine. I am working on the fuel system now and somehow I am not getting the results I need.
Having lost the instructions, it is possible that I am doing something wrong, but here is the problem. I cut the tubing with a standard cutter. Smooth the end with a scotchbright wheel. Insert to the lever that is the proper depth marker. Tighten it down, screw in the flaring part. Release.
The ends are scored and somewhat irregular. There is a bunch of aluminum on the end of the flaring bit. I tried using less force, but it doesn't seem to make any difference. Here are a couple of pictures:
[/URL][/IMG]
I hope I did the picture thing correctly.
Anyway, anyone with thoughts on this?
Regards,
Michael Wynn
RV 8
San Ramon, CA
I bought a Rolo-Flair when I was making my fuel tanks. Seemed to work fine. I am working on the fuel system now and somehow I am not getting the results I need.
Having lost the instructions, it is possible that I am doing something wrong, but here is the problem. I cut the tubing with a standard cutter. Smooth the end with a scotchbright wheel. Insert to the lever that is the proper depth marker. Tighten it down, screw in the flaring part. Release.
The ends are scored and somewhat irregular. There is a bunch of aluminum on the end of the flaring bit. I tried using less force, but it doesn't seem to make any difference. Here are a couple of pictures:
I hope I did the picture thing correctly.
Anyway, anyone with thoughts on this?
Regards,
Michael Wynn
RV 8
San Ramon, CA