J JDA_BTR Well Known Member Aug 25, 2017 #1 About to drill #36 and tap 6-32 the rear window holes into the rollbar. What tap fluid is safe or recommended for this process?
About to drill #36 and tap 6-32 the rear window holes into the rollbar. What tap fluid is safe or recommended for this process?
N Nova RV Well Known Member Aug 25, 2017 #2 I used Boelube and went very slowly with the tap (by hand of course). I would only cut a turn or two then back it out and clean out the cuttings, add more lube and cut a couple more turns.
I used Boelube and went very slowly with the tap (by hand of course). I would only cut a turn or two then back it out and clean out the cuttings, add more lube and cut a couple more turns.
R Ron B. Well Known Member Aug 25, 2017 #4 Make sure you use the revised plans for securing the small attach screws ( no thread locker as in revision 0).
Make sure you use the revised plans for securing the small attach screws ( no thread locker as in revision 0).
