AX-O
Well Known Member
I am getting ready to build a motor and wanted to step up in class during the portions of the build where catastrophic FOD inside the motor could occur.
Specifically the portion where I put a piece of cardboard where the mags and other accessories go.
So since I have been designing things on Solidworks for the plane, figured I could give this a try. The studs on the case are too long. I will fix that later. This is just a trial fit. I rounded the edges on the cover so I could easily grab it with my fingers to remove it. I also re-enforce the area with a flange in case it got smacked, it did not fall apart. The part is strong like bull.
Designed cover on Solidworks
Code transferred to Simplify 3D
Printing
Finished parts
Specifically the portion where I put a piece of cardboard where the mags and other accessories go.
So since I have been designing things on Solidworks for the plane, figured I could give this a try. The studs on the case are too long. I will fix that later. This is just a trial fit. I rounded the edges on the cover so I could easily grab it with my fingers to remove it. I also re-enforce the area with a flange in case it got smacked, it did not fall apart. The part is strong like bull.
Designed cover on Solidworks
Code transferred to Simplify 3D
Printing
Finished parts